Wallpaper industrial in industrial turquoise

Material: Non-woven wallpaper (TNT)

Thickness / weight: 150 g/m2

Finish: Matte (satin): non-glossy finish with vivid and elegant colors

100% customisable product: if you want to modify any element of the design, do not hesitate to contact us

Easily washable product: Can be gently cleaned with a damp cloth or non-abrasive sponge and water

Easy application (bubble-free): Glue directly onto the paper or wall

Suitable surface: Any flat surface

Installation tool kit available

Easy to clean: with a damp cloth and mild soap (do not use harsh products)

Fireproof certificate: M2

Easy to remove from the wall: peels off dry

Rapport / case (product repeat): 50cm

100% recyclable product: made with eco-friendly inks

You will receive your wallpaper carefully rolled in 50 cm rolls and secured with a tape to keep it compact. It will also be wrapped in bubble wrap inside a sturdy cardboard package that protects the product during shipping. If the product is shipped in a stapled lid package, you should remove the staples before taking out the wallpaper.

Application instructions are available on our website, and with the product, you will receive a QR code on the packaging that will direct you straight to them.

Hanging wallpaper or photo murals requires proper preparation and following the steps.

Recommended materials:
1. Glue
2. Bucket
3. Ruler/tape measure
4. Spirit level
5. Glue brush
6. Brush/roller
7. Cutter
8. Sponge or cloth.

Before wallpapering (preparation):

Surface: The wall must be dry, clean, free of grease and free of any residue from previous wallpaper. Fill and smooth any large imperfections.

Glue: Mix one packet of glue (150g) with 4-5 litres of water. Leave to stand for 5-10 minutes and stir. This is sufficient for up to 25 m².

Temperature: Do not apply the wallpaper at temperatures below 10∘C or in low humidity. The optimum temperature is 18−21∘C.

Application:

Marking: Use a spirit level and ruler to draw vertical guide lines every 50 cm on the wall. Start from a window frame if applicable.

Pasting: Apply a thin layer of paste to:

Option 1: Directly onto the wall (slightly wider than the roll).

Option 2: Evenly on the back of the paper, from the centre outwards. Fold the ends so that the glued parts touch and leave to rest for a few minutes to allow it to soak slightly.

Hanging: Place the top of the roll on the wall and align it with the guide line. Slide gently if necessary.

Smoothing: Use the brush from the centre outwards (top to bottom) to remove air bubbles. Avoid getting glue on the brush if it has been applied to the wall.

Continuing: Repeat the steps for the following rolls, ensuring that the edges fit together and match the design.

Clean: Remove excess glue with a damp sponge or cloth.

After gluing:

Secure: Smooth the entire surface with the roller.

Drying: Small bubbles will disappear as they dry. Keep the room temperature above 10∘C for the first few days, avoiding excessive heating.